Release Note
ZenTalk


[Replied] G sensor not working

6355 6
Jump to specific floor
Latest Post
chiaggs IND Level 1 | All posts
G sensor of my zenfone just stopped working since morning , tried to restart , reset my phone , but the problem still persists !
In the sensor test ( which opens after typing .12345+= in calci) , the green dot never comes on z+ , and gives failure error 1907
Props
IND Dr. Zen(IN) | All posts
Hello user!
Please try again and move the phone in all possible directions.
Error 1907 means the sampling frequency of the input waveform should be greater than 0 (dt greater than 0).
It takes a minute or two to test the g-sensor.It will initially show "Fail".After moving the phone in all possible directions,you will be automatically redirected to the test page and will show"Pass".
Props
IND ZenCare | All posts
recheck after preforming factory reset if still same issue suggest you to visit service center for further support after data/app backup.
Props
ITA Beta Tester | All posts
the same happens on zenfone 2
Props
ITA Beta Tester | All posts
there is a solution ?????????????????
Props
PHL Level 2 | All posts
The same happens on ZenFone 5.
Props
IDN Level 1 | All posts
The same happens on my Zenfone 3Max 
Props
Advanced mode
You need to login first Login | Register Now

Points policy of this forum

wishes

Archiver|Mobile ver.|

Fast reply Top Return to list
Share by pm